Functions and Features
1. Complete test: The Wheel Aligner can be used to measure the most wheel alignment parameters, such as front wheel toe-in, front wheel camber, caster, Kingpin inclination, rear wheel toe-in, rear wheel camber, thrust angle, wheelbase difference, tread difference, axle offset, front wheel setback and rear wheel setback, etc.
2. Complete databank: wheel alignment data of over 20,000 vehicle models is stored in the system. User can also add new data to the databank.
3. Adopts the charge coupled device (CCD) with high resolution, infrared 8-beam and full loop measurement, accurate and stable, wireless communication mode
4. Based on the thrust line to realize the real alignment measurement.
5. Front alignment test function: user can select the alignment mode flexibly. Only two probe rods are mounted can the emergency alignment measurement for the front wheels be performed.
6. The sensor heads are individually interchangeable. After changing one of the sensor heads, the other three needs not to recalibrate, which makes the after-sales service more convenient.
7. Fully intelligentized. The system can automatically recognize the vehicle with super-low chassis to perform the alignment test for this kind of vehicle and the vehicle with enclosed housing. Aiming to the vehicle model, the system can automatically turn on the corresponding functions of height measurement and counterweight, etc.
8. The demonstration version can run all test flow, which makes user’s training more convenient and quick.
9. Perform the special alignment test for Audi and Passat vehicles, etc.
10. The units of the alignment parameters can be represented with Degree/Minute, percentage degree, mm and Inch.
Specifications
Measurement Range and Precisions
Item
Measurement Precision
Measurement Range
Total toe
±4′（±0.02º）
±4º
Individual toe
±2′（±0.01º）
±2º
Camber
±2′（±0.01º）
±4º
Castor
±6′（±0.1º）
±18º
SAI / KPI
±6′（±0.1º）
±18º
Setback
±2′（±0.03º）
±2º
Thrust angle
±2′（±0.03º）
±2º
Notes:
The above accuracy can be confirmed only when the user follows the specified operation procedures.
Requirements on Surroundings
Item Specification
Ambient temperature
-20~+50℃
Relative humidity
≤90%
Packing Size
1. Cabinet packing case
740(L)x690(W)x1200(H) 0.7mз
2. Appendix packing case
870（L）x890(W)x770(H) 0.8 mз |
